How can we help you today?

Start a new topic
Discussions FAB 3000 - Gerber/CAM Software
FAB 3000 - Gerber/CAM Software 978

Online Support and FAQ for FAB 3000.

N
PDF to DXF
Posted by Numerical Support Team, over 10 years ago , Last Reply by Numerical Support Team over 10 years ago
N
I have a need to import a pdf file. The process completes with the message: Count: Block-1; 0 Total Object Imported.
Posted by Numerical Support Team, over 10 years ago , Last Reply by Numerical Support Team over 10 years ago
N
When merging gerber files, and one uses a plane that is negative on one and positive on other, does this tool convert them to be same?
Posted by Numerical Support Team, about 14 years ago , Last Reply by guiraud almost 11 years ago
N
Error while unpacking program, code :LP5
Posted by Numerical Support Team, almost 11 years ago , Last Reply by Numerical Support Team almost 11 years ago
N
My ground layer was imported as eps and exported as gerber . The gerber size is over 16 Megabytes.
Posted by Numerical Support Team, almost 11 years ago , Last Reply by Numerical Support Team almost 11 years ago
N
EPS (Postscript) to Gerber conversion. Why weren't all the round pads converted to flashes on import?
Posted by Numerical Support Team, almost 11 years ago , Last Reply by Numerical Support Team almost 11 years ago
J
FAB 3000 de-embedding puts cut lines on a 5 degree angle
Posted by Jeffrey Messer, almost 11 years ago , Last Reply by Numerical Support Team almost 11 years ago
N
The netlist extraction does not appear correct when I have 2 Blind Drill files.
Posted by Numerical Support Team, almost 11 years ago , Last Reply by Numerical Support Team almost 11 years ago
N
Attached you will find two gerber files that can be imported but when you try to export them as gerber files it will give an exception error.
Posted by Numerical Support Team, almost 11 years ago
N
For the solder side, I didn't use mirror option in gerber-274x -- is that okay?
Posted by Numerical Support Team, almost 11 years ago , Last Reply by Numerical Support Team almost 11 years ago