Numerical Innovations - Help Center

Showing recently popular topics

• Remove or Modify ODB++ Netlist and Component Data
  Posted by Kevin, about 2 hours ago

  Last Reply by Kevin about 2 hours ago
• I'd like to create a PDF representation of the panels that I make that show the frame of the panel and array/matrix of the PCB when submitting to board vendors. When I go to generate this PDF all I am able to see is the matrix/array grid and the lines fo
  Posted by Simon Garrison, 7 days ago

  Last Reply by Simon Garrison 7 days ago
• when importing layers I see 2 nodes which are not connected (many nodes are connected correct), while my colleague has the same version and same settings and he has the nodes correct connected after importing GKO layer.
  Posted by Simon Garrison, 8 days ago

  Last Reply by Simon Garrison 8 days ago
• I got a message - Unable to Create a Temporary folder. I used to be able to open more than one job window.
  Posted by Simon Garrison, 8 days ago

  Last Reply by Simon Garrison 8 days ago
• I created some DFM profiles and panel sizes in the software that it would like to share with my colleagues. Is that possible?
  Posted by Simon Garrison, 10 days ago

  Last Reply by Simon Garrison 10 days ago
• Gerber import error - UNable to create pad. Pad found with 0 or Negative Width, invalid. Warning: Unable to Create Pad - Flashes Cannot be Zero Width - Invalid Dcode Unable to Add Flash.
  Posted by Simon Garrison, 21 days ago

  Last Reply by Simon Garrison 21 days ago
• DFM Error PDF report doesn't match Error List
  Posted by Simon Garrison, 22 days ago

  Last Reply by Simon Garrison 22 days ago
• Exporting Blocks. When converting from DXF to Gerber, my DXF file has blocks that I would like to export and remain as blocks. Is this possible in V8, I know I could do this in V6.
  Posted by Simon Garrison, 22 days ago

  Last Reply by Simon Garrison 22 days ago
• Aperture: Rectangle/ Custom(MACRO)
  Posted by Simon Garrison, 24 days ago

  Last Reply by Simon Garrison 24 days ago