CAM Engineering and DFM Questions (1091)

Can you indicate to me which ODB++ version , including the sub release version, you support with you FAB 3000 v.7 tool?

Posted about 10 years ago by Numerical Support Team, Last Reply by Numerical Support Team about 10 years ago

It looks good when I add text and save on Fab3000 job but when I export files in dxf the top text is overlapped with bottom.

Posted about 10 years ago by Numerical Support Team, Last Reply by Numerical Support Team about 10 years ago

I loaded my Gerber files into FAB 3000, and now when I export X,Y Centroids I get a message stating "Missing Either Top or Bottom Components layer."

Posted about 10 years ago by Numerical Support Team, Last Reply by Danny Carr over 6 years ago

Gerber to Centroid

Posted about 10 years ago by tom, Last Reply by Numerical Support Team about 10 years ago

I received a gerber that has a lot of other documentation. How do i remove all the extra documentation?

Posted about 10 years ago by Numerical Support Team, Last Reply by Numerical Support Team about 10 years ago

Would you please see why FAB3000 will not open the attached DXF file? I can open it with other software but not yours.

Posted about 10 years ago by Numerical Support Team

Only Pulsonix 8.5 Gerber files did not load correctly - there were extra circles. Could you let me know why?

Posted about 10 years ago by Numerical Support Team, Last Reply by Numerical Support Team about 10 years ago

Acid Traps

Posted over 10 years ago by Ian Hansford, Last Reply by Ian Hansford over 10 years ago

ISO and ANSI

Posted over 10 years ago by R. Naranjo, Last Reply by Numerical Support Team over 10 years ago

Trying to generate a fabrication drawing. I get error message that says no boarder layer specified --- but there is one specified.

Posted over 10 years ago by Numerical Support Team, Last Reply by Numerical Support Team over 10 years ago