CAM Engineering and DFM Questions (1105)

Need assistance setting up a FAB 3000 Floating license (using FlexLM) on my client computer. Can you help?

Posted about 10 years ago by Numerical Support Team, Last Reply by Danny Carr over 7 years ago

Can you show me how to merge 3 PCB's and setup on a Panel plus generate Rout with tabs, etc?

Posted about 10 years ago by Numerical Support Team

Can I convert legacy Film to Gerber files with FAB 3000?

Posted about 10 years ago by Numerical Support Team

The “Layer Detection Table…” doesn’t seem to take more comma entries after “comp_+_top & bot”” for “Components Top” and “Components Bottom”.

Posted about 10 years ago by Numerical Support Team

I would like to import a Centroid file and check it against my Gerbers. Is that possible with FAB 3000?

Posted about 10 years ago by Numerical Support Team

Is there a way to update the Gerber files after the apertures are updated?

Posted about 10 years ago by Numerical Support Team, Last Reply by Numerical Support Team about 10 years ago

Convert DXF to Gerber, and then I noticed small gaps in the traces when performing a DFM Check.

Posted about 10 years ago by Numerical Support Team

Import DXF, perform Step/Repeat, and export to Postscript file (EPS) which is fully compatible with Xerox Inkjet.

Posted about 10 years ago by Numerical Support Team

RS-274-D Gerber file - Thermal Apertures

Posted about 10 years ago by Numerical Support Team, Last Reply by Numerical Support Team about 10 years ago

When I measure it is in English,…how do I change that to metric ?

Posted about 10 years ago by Numerical Support Team