CAM Engineering and DFM Questions (1090)

Can the fab 3000 add mouse bites and rout for tabs? How difficult is it?

Posted almost 10 years ago by Numerical Support Team

Drill reports are blank, yet I imported the drill file. Can you help?

Posted almost 10 years ago by Numerical Support Team

How do I convert 3 separate DXF files into ODB++?

Posted almost 10 years ago by Numerical Support Team, Last Reply by Danny Carr over 6 years ago

The open-file-dialog, shows *local* drives only. Virtual drives with mapped network-connections are no longer accessible.

Posted almost 10 years ago by Numerical Support Team

Can you explain the difference in data of the files I sent you. Is it possible to reduce the size of the top_mask gerber?

Posted almost 10 years ago by Numerical Support Team, Last Reply by Numerical Support Team almost 10 years ago

Need assistance setting up a FAB 3000 Floating license (using FlexLM) on my client computer. Can you help?

Posted almost 10 years ago by Numerical Support Team, Last Reply by Danny Carr almost 7 years ago

Can you show me how to merge 3 PCB's and setup on a Panel plus generate Rout with tabs, etc?

Posted almost 10 years ago by Numerical Support Team

Can I convert legacy Film to Gerber files with FAB 3000?

Posted almost 10 years ago by Numerical Support Team

The “Layer Detection Table…” doesn’t seem to take more comma entries after “comp_+_top & bot”” for “Components Top” and “Components Bottom”.

Posted almost 10 years ago by Numerical Support Team

I would like to import a Centroid file and check it against my Gerbers. Is that possible with FAB 3000?

Posted almost 10 years ago by Numerical Support Team