Start a new topic

Panel Setup - Tooling Holes


Add NC Tooling Holes and then enter Width, Height, Coordinates, and Rotation.



Available Tooling Hole Shapes: 

Drill - A circular hole (not plated)

Slot - A drilled slot .


Width:

The width to use for the tooling hole.


Height (for Slots only):

The height to use for the tooling hole.


Center Point X, Y :

Assign the center point for the tooling hole.


Relative X,Y Coordinates are supported:

You may use Relative X,Y Coordinates requires the at-sign @    (See below for examples)

X = @-1   Y = @0.25   would result in -1 (from Panel Right) and 0.25 (from Panel Bottom)

X = @0.5   Y = @-0.75   would result in 0.5 (from Panel Left) and -0.75 (from Panel Top)


Rotate (for Slots only):

Assign the rotation (in degrees) for the slot.  Default is 0.0.


Clearance:

Add a clearance around the tooling hole.  Set 0 for no clearance.



Login or Signup to post a comment