I don't have a drill file - is there a way I can create one?
N
Numerical Support Team
started a topic
almost 17 years ago
If you have a gerber file that contains all required drill holes, you can create a drill file by performing the following: 1. Go to menu: Fabrication / Drill / Gerber Layer to Drill.
2. Review options and press OK. This will create a new drill layer and convert all flashed pads to Drill hits.
If you don't have a gerber file that contains all require drill holes, please perform the following: 1. Go to menu : Tools | Generate NC Drill-Rout / Drill (PTH)...
2. Review options and press OK. This feature will determine if a pad exists on both the top & bottom sides; if so, a drill hole will be added.
Numerical Support Team
1. Go to menu: Fabrication / Drill / Gerber Layer to Drill.
2. Review options and press OK.
This will create a new drill layer and convert all flashed pads to Drill hits.
If you don't have a gerber file that contains all require drill holes, please perform the following:
1. Go to menu : Tools | Generate NC Drill-Rout / Drill (PTH)...
2. Review options and press OK.
This feature will determine if a pad exists on both the top & bottom sides; if so, a drill hole will be added.