Ive looked and cant find cutter compensation in FAB 3000 is this a feature?

Posted about 17 years ago by Numerical Support Team

Post a topic

Numerical Support Team

To assign cutter compensation to routed paths, please perform the following:

1. Place FAB 3000 into NC Editor Mode (menu: Windows | NC Editor Mode)
2. Select the rout, and go to menu: Edit | NC Properties...
3. Then assign "Compensation Side".

Note: Make sure to turn Fill Mode on to view the compensation offsets (menu: View | Fill)

0 Votes

0 Comments

Ive looked and cant find cutter compensation in FAB 3000 is this a feature?

Ive looked and cant find cutter compensation in FAB 3000 is this a feature?