How can we help you today?

Start a new topic
Discussions FAB 3000 - Gerber/CAM Software
FAB 3000 - Gerber/CAM Software 995

Online Support and FAQ for FAB 3000.

T
Net List Extraction Wizard lockup.
Posted by Tom Sidauskas, almost 16 years ago , Last Reply by Tom Sidauskas almost 16 years ago
N
How can I improve the results when I convert from Gerber to DXF? I need a DXF file with clean outlines for all gerber geometries.
Posted by Numerical Support Team, almost 16 years ago
N
I also had problems in importing older gerber data with apertures files
Posted by Numerical Support Team, almost 16 years ago
N
We need to change solder paste mask gerber aperture sizes. Is there a way in your editor to globally change all apertures say 10% reduction?
Posted by Numerical Support Team, almost 16 years ago
N
I need to convert a gerber file to a drill file, but the gerber only contains drawn circles for the drill holes (no flashes).
Posted by Numerical Support Team, almost 16 years ago
N
When converting dxf to gerber files, is it possible to set one width for lines/arcs and another width for text?
Posted by Numerical Support Team, almost 16 years ago
N
Is it possible to shift a selection an exact amount, rather than dragging and dropping?
Posted by Numerical Support Team, almost 16 years ago
W
XFree86-DRI missing on display ":0.0"
Posted by Wilbur Harvey, almost 16 years ago , Last Reply by Numerical Support Team almost 16 years ago
N
When importing a DXF, it is not using our custom SHX font.
Posted by Numerical Support Team, almost 16 years ago
N
What's the best way to change the grid so that I can line up the external netlist and the ODB++ data closer?
Posted by Numerical Support Team, about 16 years ago