CAM Engineering and DFM Questions (1092)

Is there a way in the Fab3000 software to do Copper Area Calculations on each layer?

Posted about 10 years ago by Numerical Support Team, Last Reply by Numerical Support Team about 10 years ago

What is SELECT Fence?

Posted about 10 years ago by Numerical Support Team

Compare two sets of Gerber layers and report the difference.

Posted about 10 years ago by Numerical Support Team, Last Reply by Danny Carr about 7 years ago

Flexnet Floating License Installation questions

Posted about 10 years ago by Numerical Support Team, Last Reply by Danny Carr about 7 years ago

Using Dynamic Editing

Posted about 10 years ago by Numerical Support Team, Last Reply by Numerical Support Team about 10 years ago

I have one component on a board that I cannot build. I have attached the .WRK file for the job and an image showing the problem component.

Posted about 10 years ago by Numerical Support Team, Last Reply by Numerical Support Team about 10 years ago

I’ve tried to build the components but I have is meant for leaded auto-mount parts, not surface mounted parts.

Posted over 10 years ago by Numerical Support Team, Last Reply by Numerical Support Team over 10 years ago

During X/Y centroid generation, several of my devices were automatically defined incorrectly and need to be edited.

Posted over 10 years ago by Numerical Support Team, Last Reply by Numerical Support Team over 10 years ago

I have loaded the project and tried to export the centroid xy file, but I am getting an error "Missing Either Top or Bottom Components layer.

Posted over 10 years ago by Numerical Support Team, Last Reply by Danny Carr about 7 years ago

Edit a Silkscreen

Posted over 10 years ago by Numerical Support Team, Last Reply by Numerical Support Team over 10 years ago