CAM Engineering and DFM Questions (1116)

Trying to run FAB3000 and it won't load any of my gerbers no matter what I do. Yet these are files I have loaded with FAB 3000 in the past.

Posted about 15 years ago by Numerical Support Team, Last Reply by Numerical Support Team about 15 years ago

How effective is FAB 3000 in finding possible air-gap problems.

Posted about 15 years ago by Numerical Support Team, Last Reply by Numerical Support Team about 15 years ago

Will FAB 3000 allow one to compare the PCB layout IPC-D-356A netlist with a netlist generated from the Gerbers?

Posted about 15 years ago by Numerical Support Team, Last Reply by Numerical Support Team about 15 years ago

After gerber export, an error message appears on both our plotters stating that there is an open outline in the macro.

Posted about 15 years ago by Numerical Support Team, Last Reply by Numerical Support Team about 15 years ago

Selection Filter and Teardrops.

Posted about 15 years ago by Numerical Support Team, Last Reply by Simon Garrison almost 5 years ago

Select All & Deselect All Check Boxes

Posted over 15 years ago by hamid, Last Reply by hamid over 15 years ago

Using FAB 3000 to convert GDSII to Gerber for PCB manufacturing.

Posted over 15 years ago by Numerical Support Team

We modified the pads on a gerber layer that is going to use for creating an stencil, using the SMT Stencil features: Homebase Pads.

Posted over 15 years ago by Numerical Support Team, Last Reply by Numerical Support Team over 15 years ago

I then exported the gerbers using units "Inch", and the "Decimal Digits" of "1". Now when I reload the gerbers they look wrong. What happened?

Posted over 15 years ago by Numerical Support Team

Replacing Dcode's shape

Posted over 15 years ago by hamid, Last Reply by Numerical Support Team over 15 years ago