CAM Engineering and DFM Questions (1090)

Question with DFM rule do you have standard Rule set that base on IPC Spec?

Posted over 14 years ago by Numerical Support Team, Last Reply by Numerical Support Team over 14 years ago

Can I remove the "Layer Type" colors found in the Layers Window?

Posted over 14 years ago by Numerical Support Team, Last Reply by Numerical Support Team over 14 years ago

How do I switch the display from a "White Background" to a "Black Background"?

Posted over 14 years ago by Numerical Support Team

NC Mill export, invalid entry

Posted over 14 years ago by Lisandro Bravo, Last Reply by Numerical Support Team over 14 years ago

Trying to run FAB3000 and it won't load any of my gerbers no matter what I do. Yet these are files I have loaded with FAB 3000 in the past.

Posted over 14 years ago by Numerical Support Team, Last Reply by Numerical Support Team over 14 years ago

How effective is FAB 3000 in finding possible air-gap problems.

Posted over 14 years ago by Numerical Support Team, Last Reply by Numerical Support Team over 14 years ago

Will FAB 3000 allow one to compare the PCB layout IPC-D-356A netlist with a netlist generated from the Gerbers?

Posted over 14 years ago by Numerical Support Team, Last Reply by Numerical Support Team over 14 years ago

After gerber export, an error message appears on both our plotters stating that there is an open outline in the macro.

Posted over 14 years ago by Numerical Support Team, Last Reply by Numerical Support Team over 14 years ago

Selection Filter and Teardrops.

Posted over 14 years ago by Numerical Support Team, Last Reply by Simon Garrison about 4 years ago

Select All & Deselect All Check Boxes

Posted over 14 years ago by hamid, Last Reply by hamid over 14 years ago