CAM Engineering and DFM Questions (1092)

Importing .jpeg of scanned PCB into FAB3000 (scale).

Posted over 8 years ago by Simon Garrison, Last Reply by Simon Garrison over 8 years ago

build component angles

Posted over 8 years ago by Simon Garrison, Last Reply by Simon Garrison over 8 years ago

netlist errors

Posted over 8 years ago by Simon Garrison, Last Reply by Simon Garrison over 8 years ago

The External net ***** and CAM net ***** differ at same location /

Posted over 8 years ago by Simon Garrison, Last Reply by Simon Garrison over 8 years ago

Panel Wizard Fiducials and Rails

Posted over 8 years ago by Jim Bundock

But software crashes when I try to run DFM checks.

Posted over 8 years ago by Simon Garrison, Last Reply by Simon Garrison over 8 years ago

Unfortunately, my matrix file (although I think it looks valid) doesn’t work. STEPREPEAT section seems to be the problem. Could you please help me with this?

Posted over 8 years ago by Simon Garrison, Last Reply by Simon Garrison over 8 years ago

During Build components there was a component that had different pad and is impossible to create. How can I create this component, and how do I add THT components?

Posted over 8 years ago by Simon Garrison

During build components, how do I get it to work with non ortho angles?

Posted over 8 years ago by Simon Garrison

During build components there should be one component not two.

Posted over 8 years ago by Simon Garrison