How can we help you today?

Start a new topic
Discussions FAB 3000 - Gerber/CAM Software
FAB 3000 - Gerber/CAM Software 1040

Online Support and FAQ for FAB 3000.

S
netlist errors
Posted by Simon Garrison, over 7 years ago , Last Reply by Simon Garrison over 7 years ago
S
The External net ***** and CAM net ***** differ at same location /
Posted by Simon Garrison, over 7 years ago , Last Reply by Simon Garrison over 7 years ago
J
Panel Wizard Fiducials and Rails
Posted by Jim Bundock, over 7 years ago
S
But software crashes when I try to run DFM checks.
Posted by Simon Garrison, over 7 years ago , Last Reply by Simon Garrison over 7 years ago
S
fiducials on v-rails of the panel
Posted by Simon Garrison, over 8 years ago , Last Reply by Jim Bundock over 7 years ago
S
Unfortunately, my matrix file (although I think it looks valid) doesn’t work. STEPREPEAT section seems to be the problem. Could you please help me with this?
Posted by Simon Garrison, over 7 years ago , Last Reply by Simon Garrison over 7 years ago
S
During Build components there was a component that had different pad and is impossible to create. How can I create this component, and how do I add THT components?
Posted by Simon Garrison, over 7 years ago
S
During build components, how do I get it to work with non ortho angles?
Posted by Simon Garrison, over 7 years ago
S
During build components there should be one component not two.
Posted by Simon Garrison, over 7 years ago
S
I try to add components (build components) in gerber layers without netlist file. I can’t build these component (red rectangle) because next component has to large package.
Posted by Simon Garrison, over 7 years ago