ACE Translator 3000 (CAD to EDA Translator) (388)

I want to convert my design to DXF. Is it possible to perform [MERGE] only on specified layers?

Posted about 2 years ago by Simon Garrison

DXF Export: Is it possible to output polygons as circles?

Posted about 2 years ago by Simon Garrison

Text Font changes when converting dxf to gbr

Posted over 2 years ago by Simon Garrison

I have been trying to convert my file from .step to Gerber, but this screen has been sitting for almost an hour without anything happening. Does the bar on the bottom of the screen indicate that the upload is complete? If so, where it the file?

Posted over 2 years ago by Simon Garrison

During DXF Import, I use many unique options that are not the standard defaults. How can I save all these settings and reuse again?

Posted over 2 years ago by Simon Garrison

ACE successfully converts my PDF to DXF, but when opening in CATIA I get an error message saying no file editor selected

Posted over 2 years ago by Simon Garrison

convert a DXF file to a NC Drill

Posted over 2 years ago by ABDELHARIZ Chaouki

ACE Version 8 starts up and then shuts down. Why?

Posted over 2 years ago by Simon Garrison

ACE Translator will not start, so I can't enter my activation code.

Posted over 2 years ago by Simon Garrison

I have to fill all the areas indicated by the cursor in my DXF. How can I do ?

Posted over 2 years ago by Simon Garrison, Last Reply by Simon Garrison over 2 years ago