CAM Engineering and DFM Questions (1093)

Separate plated and non-plated thru holes in a design here the designer included both on the same drill file.

Posted about 12 years ago by Numerical Support Team, Last Reply by Numerical Support Team about 12 years ago

Centroid File Generation Guide from Screaming Circuits.

Posted about 12 years ago by Numerical Support Team

Can FAB 3000 compare one gerber file to another gerber file? And pin point any changes from one to the other?

Posted about 12 years ago by Numerical Support Team

Problem converting drawn pads to Flashes and then export to drill data.

Posted about 12 years ago by Numerical Support Team, Last Reply by Numerical Support Team about 12 years ago

I'm trying to panelize two different layouts.

Posted about 12 years ago by Numerical Support Team, Last Reply by Numerical Support Team about 12 years ago

I’m trying to import an RS274-D gerber. I load in my aperture file (Tango II).

Posted about 12 years ago by Numerical Support Team, Last Reply by Danny Carr about 7 years ago

I'm having trouble running "Apply External Netlist"

Posted about 12 years ago by Numerical Support Team, Last Reply by Numerical Support Team about 12 years ago

I'm having trouble using the Setup > Blind and Buried Via Setup command.

Posted about 12 years ago by Numerical Support Team, Last Reply by Danny Carr about 7 years ago

Building Components I'm having trouble trying to designate the proper layers as "top" and "silkscreen".

Posted about 12 years ago by Numerical Support Team, Last Reply by Numerical Support Team about 12 years ago

Will FAB 3000 do minimum trace width and minimum clearance checks?

Posted about 12 years ago by Numerical Support Team