I haven't figure out how to get a border defined. Without that I can't get it to do much. Spent about 30 minutes on it and then ran out of time.

Posted over 10 years ago by Numerical Support Team

Post a topic

You must be logged in to access this page

Numerical Support Team

To generate a PCB border, please perform the following:

1. Import your Gerbers, Drills, etc.
2. Go to menu: Fabrication / Detect Border (Automatic)...

Note: FAB 3000 will instantly detect your border layer. Should there be any problems, try manually selecting an edge of the border. Go to menu: Fabrication / Generate Missing Layers / Border (Selective)...

Here's a quick tutorial (no sound):

https://numericalsoftware-update.s3.amazonaws.com/tutorials/2016-01-14_14-05-35.mp4

Thanks again, and please let me know if you have any other questions.

Best regards,
Simon

0 Votes

0 Comments