How do I change the editor UNITS displayed in FAB 3000? I prefer to work with Millimeter units however FAB 3000 is defaulted to Inches.

Posted about 4 years ago by Simon Garrison

Post a topic

You must be logged in to access this page

Simon Garrison Admin

To change the FAB 3000 editor units, go to menu: View / Units or select the FAB 3000 editor Units from the lower-right corner of the editor.

Important: Set as Default...

Use this command to permanently make FAB 3000 keep your preferred units.

Or go to menu: Setup | Options..., and select your preferred units from the option "Default Units (at start up)".

0 Votes

0 Comments