I have an evaluation copy of FAB 3000. I was hoping I could use it to remove traces that pass thru or end at a pad.

Posted almost 11 years ago by Numerical Support Team

Post a topic

You must be logged in to access this page

Numerical Support Team

I have an evaluation copy of FAB 3000. I was hoping I could use it to remove traces that pass thru or end at a pad. I want to keep the center of the pad clear so that it can serve as a center mark for drilling of prototype boards. Is there a way to do this? Thank you

0 Votes

2 Comments

Simon Garrison posted over 6 years ago Admin

Here's more information about composite layers (which should help understanding how they are used):

https://support.numericalinnovations.com/support/discussions/topics/14000002419

0 Votes

Numerical Support Team posted almost 11 years ago

I came up with a real easy solution - assuming you have the "Drill File".

Just use the command "Build Composite". See my quick tutorial link below (no sound):

https://numericalsoftware-update.s3.amazonaws.com/tutorials/2015-05-11_20-40-45.mp4

1. Load Gerbers and Drill.
2. Using command "Build Composite" create a new layer which is the Gerber layer minus the drill layer. It will create a new layer which uses Top Layer (or whatever you select) minus Drill..

Best regards,
Simon

0 Votes