Exporting Drill generation is happen, But Gerber viewer it's appearing all the drill is in one place(Origin).

Posted over 10 years ago by Numerical Support Team

Post a topic

Numerical Support Team

Importing allegro (Gerber and Drill) file in FAB3000 it's Woking fine. Merging Panel also Woking fine.

Now, Exporting Gerber file it's working fine. Exporting Drill generation is happen, But Gerber viewer it's appearing all the drill is in one place(Origin).

Note: we are using another Greber viewer.

0 Votes

2 Comments

Danny Carr posted almost 7 years ago

Note: the above link has been updated. Please use the new links below:

trouble loading drill file with few holes

https://support.numericalinnovations.com/support/discussions/topics/14000003635

fab 3000 not loading dril

https://support.numericalinnovations.com/support/discussions/topics/14000003080

Search results for "Drill Import"
https://support.numericalinnovations.com/support/search/topics?term=Drill+Import&authenticity_token=eb195PV3BmBuvC5cQKp4pGTgsgBicJZC3OSyulFZEgY%3D

0 Votes

Numerical Support Team posted over 10 years ago

Thanks for your question. Most likely you have exported the Drill file correctly, and the Gerber viewer is incorrectly loading it. Please remember Drill files are just XY coordinates with "no decimal place". It is up to the Viewer to determine where the decimal place should go; if the viewer places the decimal point in the wrong place all imported drills will look as if it overlaps. This is a common issue for all Gerber Viewers and CAM software alike (since drill data is very vague). Here's a similar Drill Import from the user forum:

http://forums.numericalinnovations.com/post/fab-3000-not-loading-drill-6156501?highlight=drill

To resolve the issue when your exporting the Drill (from FAB 3000) please take note of the Integer/Decimal digits. When importing Drill into a Gerber viewer, please make sure to use the same Integer/Decimal digit settings. See screen capture: http://screencast.com/t/8xXKTwYa

0 Votes