How can we help you today?

Start a new topic
Discussions FAB 3000 - Gerber/CAM Software
FAB 3000 - Gerber/CAM Software 977

Online Support and FAQ for FAB 3000.

N
difficult to measure between traces using object-to-object if a trace is sub-divided into several adjacent objects instead of one single object
Posted by Numerical Support Team, over 15 years ago
N
When import the gerber and drill file, detect the drill hole is not in place (mean location for the hole is not same with the design). Why this happen
Posted by Numerical Support Team, over 15 years ago
T
Net List Extraction Wizard lockup.
Posted by Tom Sidauskas, over 15 years ago , Last Reply by Tom Sidauskas over 15 years ago
N
How can I improve the results when I convert from Gerber to DXF? I need a DXF file with clean outlines for all gerber geometries.
Posted by Numerical Support Team, over 15 years ago
N
I also had problems in importing older gerber data with apertures files
Posted by Numerical Support Team, over 15 years ago
N
We need to change solder paste mask gerber aperture sizes. Is there a way in your editor to globally change all apertures say 10% reduction?
Posted by Numerical Support Team, over 15 years ago
N
I need to convert a gerber file to a drill file, but the gerber only contains drawn circles for the drill holes (no flashes).
Posted by Numerical Support Team, over 15 years ago
N
When converting dxf to gerber files, is it possible to set one width for lines/arcs and another width for text?
Posted by Numerical Support Team, over 15 years ago
N
Is it possible to shift a selection an exact amount, rather than dragging and dropping?
Posted by Numerical Support Team, over 15 years ago
W
XFree86-DRI missing on display ":0.0"
Posted by Wilbur Harvey, over 15 years ago , Last Reply by Numerical Support Team over 15 years ago