CAM Engineering and DFM Questions (1094)

Will FAB 3000 allow one to compare the PCB layout IPC-D-356A netlist with a netlist generated from the Gerbers?

Posted almost 15 years ago by Numerical Support Team, Last Reply by Numerical Support Team almost 15 years ago

After gerber export, an error message appears on both our plotters stating that there is an open outline in the macro.

Posted almost 15 years ago by Numerical Support Team, Last Reply by Numerical Support Team almost 15 years ago

Selection Filter and Teardrops.

Posted almost 15 years ago by Numerical Support Team, Last Reply by Simon Garrison over 4 years ago

Select All & Deselect All Check Boxes

Posted almost 15 years ago by hamid, Last Reply by hamid almost 15 years ago

Using FAB 3000 to convert GDSII to Gerber for PCB manufacturing.

Posted almost 15 years ago by Numerical Support Team

We modified the pads on a gerber layer that is going to use for creating an stencil, using the SMT Stencil features: Homebase Pads.

Posted almost 15 years ago by Numerical Support Team, Last Reply by Numerical Support Team almost 15 years ago

I then exported the gerbers using units "Inch", and the "Decimal Digits" of "1". Now when I reload the gerbers they look wrong. What happened?

Posted almost 15 years ago by Numerical Support Team

Replacing Dcode's shape

Posted about 15 years ago by hamid, Last Reply by Numerical Support Team about 15 years ago

I have a problem with importing apertures from folder with 274d Tango files.

Posted about 15 years ago by Numerical Support Team, Last Reply by Numerical Support Team about 15 years ago

How to install FAB 3000 on Ubuntu Linux.

Posted about 15 years ago by Numerical Support Team, Last Reply by Numerical Support Team about 15 years ago