CAM Engineering and DFM Questions (1116)

I am trying to read in the attached .rar file but will not read the aperture list, I have tried typing them in manually in without success.

Posted almost 13 years ago by Numerical Support Team, Last Reply by Numerical Support Team almost 13 years ago

Add Traces with Clearance with a Copper fill on a PCB Ground Layer.

Posted almost 13 years ago by Numerical Support Team, Last Reply by Numerical Support Team almost 13 years ago

Routing Outline overlaps board edge

Posted almost 13 years ago by Todd Albertson, Last Reply by Numerical Support Team almost 13 years ago

Print PDF

Posted almost 13 years ago by Numerical Support Team, Last Reply by Danny Carr over 7 years ago

Does FAB 3000 have Backside View?

Posted almost 13 years ago by Numerical Support Team

PDF to DXF

Posted almost 13 years ago by Numerical Support Team, Last Reply by Numerical Support Team almost 13 years ago

I have a need to import a pdf file. The process completes with the message: Count: Block-1; 0 Total Object Imported.

Posted almost 13 years ago by Numerical Support Team, Last Reply by Numerical Support Team almost 13 years ago

Error while unpacking program, code :LP5

Posted about 13 years ago by Numerical Support Team, Last Reply by Numerical Support Team about 13 years ago

My ground layer was imported as eps and exported as gerber . The gerber size is over 16 Megabytes.

Posted about 13 years ago by Numerical Support Team, Last Reply by Numerical Support Team about 13 years ago

EPS (Postscript) to Gerber conversion. Why weren't all the round pads converted to flashes on import?

Posted about 13 years ago by Numerical Support Team, Last Reply by Numerical Support Team about 13 years ago