How can we help you today?

Start a new topic
Discussions FAB 3000 (Gerber-CAM Software)
CAM Engineering and DFM Questions 1087

Online Support and FAQ for Gerber and CAM Software

N
When I open more then one gerber at the same time in FAB3000 V7 the first one can not be exported anymore.
Posted by Numerical Support Team, over 11 years ago , Last Reply by Numerical Support Team over 11 years ago
N
I'm trying to panelize two different layouts. The tool numbers in the drill files are not the same for the same drills
Posted by Numerical Support Team, over 11 years ago , Last Reply by Numerical Support Team over 11 years ago
N
Can you give me a hint on the best route to start learning the ins and outs of using FAB3000?
Posted by Numerical Support Team, almost 12 years ago
N
Would b really nice to have center-to-center object measure command
Posted by Numerical Support Team, almost 12 years ago , Last Reply by Numerical Support Team almost 12 years ago
N
How to Panelize Gerbers from Eagle PCB?
Posted by Numerical Support Team, almost 12 years ago , Last Reply by Numerical Support Team almost 12 years ago
N
Can FAB 3000 be used to add or move vias and parts in Gerber Files?
Posted by Numerical Support Team, almost 12 years ago
N
Please can you let me know if it is possible to add these shapes to the drill layer and also how to rout my PCB border?
Posted by Numerical Support Team, about 12 years ago , Last Reply by Numerical Support Team about 12 years ago
N
I am trying to read in the attached .rar file but will not read the aperture list, I have tried typing them in manually in without success.
Posted by Numerical Support Team, about 12 years ago , Last Reply by Numerical Support Team about 12 years ago
N
Add Traces with Clearance with a Copper fill on a PCB Ground Layer.
Posted by Numerical Support Team, about 12 years ago , Last Reply by Numerical Support Team about 12 years ago
T
Routing Outline overlaps board edge
Posted by Todd Albertson, about 12 years ago , Last Reply by Numerical Support Team about 12 years ago