CAM Engineering and DFM Questions (1092)

I'm trying to panelize two different layouts. The tool numbers in the drill files are not the same for the same drills

Posted almost 12 years ago by Numerical Support Team, Last Reply by Numerical Support Team almost 12 years ago

Can you give me a hint on the best route to start learning the ins and outs of using FAB3000?

Posted about 12 years ago by Numerical Support Team

Would b really nice to have center-to-center object measure command

Posted about 12 years ago by Numerical Support Team, Last Reply by Numerical Support Team about 12 years ago

How to Panelize Gerbers from Eagle PCB?

Posted about 12 years ago by Numerical Support Team, Last Reply by Numerical Support Team about 12 years ago

Can FAB 3000 be used to add or move vias and parts in Gerber Files?

Posted about 12 years ago by Numerical Support Team

Please can you let me know if it is possible to add these shapes to the drill layer and also how to rout my PCB border?

Posted about 12 years ago by Numerical Support Team, Last Reply by Numerical Support Team about 12 years ago

I am trying to read in the attached .rar file but will not read the aperture list, I have tried typing them in manually in without success.

Posted about 12 years ago by Numerical Support Team, Last Reply by Numerical Support Team about 12 years ago

Add Traces with Clearance with a Copper fill on a PCB Ground Layer.

Posted over 12 years ago by Numerical Support Team, Last Reply by Numerical Support Team over 12 years ago

Routing Outline overlaps board edge

Posted over 12 years ago by Todd Albertson, Last Reply by Numerical Support Team over 12 years ago

Print PDF

Posted over 12 years ago by Numerical Support Team, Last Reply by Danny Carr almost 7 years ago