CAM Engineering and DFM Questions (1091)

Aperture list optimize?

Posted almost 11 years ago by Danny Carr, Last Reply by Numerical Support Team over 10 years ago

Question on the polarity of the layers, what is that exactly?

Posted almost 11 years ago by Numerical Support Team, Last Reply by Numerical Support Team almost 11 years ago

Produce negative print for the TOP (and inverted ) and BOTTOM copper.

Posted almost 11 years ago by Numerical Support Team, Last Reply by Numerical Support Team almost 11 years ago

Panelize Non-Rectangular PCB's

Posted almost 11 years ago by Numerical Support Team

I can edit traces etc. Does the software permit copying or creating a via like one already on the board?

Posted almost 11 years ago by Numerical Support Team

Drill Import Problems: Drill_77 drill much too big and looks like the holes are in the wrong place.

Posted almost 11 years ago by Numerical Support Team, Last Reply by Danny Carr almost 7 years ago

Netlist Extraction Short

Posted almost 11 years ago by Numerical Support Team, Last Reply by Numerical Support Team almost 11 years ago

How do I easily convert selected pads to round rectangle?

Posted about 11 years ago by Numerical Support Team

I also encounter the drill layer was smaller than the whole PCB, I got stuck there, I’ve been trying to find out how to align this kind of layer.

Posted about 11 years ago by Numerical Support Team

Can the DFM rule be expanded/or have more additional rules?

Posted about 11 years ago by Numerical Support Team