How can we help you today?

Start a new topic
Discussions FAB 3000 (Gerber-CAM Software)
CAM Engineering and DFM Questions 1083

Online Support and FAQ for Gerber and CAM Software

S
I'd like to create a PDF representation of the panels that I make that show the frame of the panel and array/matrix of the PCB when submitting to board vendors. When I go to generate this PDF all I am able to see is the matrix/array grid and the lines fo
Posted by Simon Garrison, 4 months ago
S
when importing layers I see 2 nodes which are not connected (many nodes are connected correct), while my colleague has the same version and same settings and he has the nodes correct connected after importing GKO layer.
Posted by Simon Garrison, 4 months ago
S
I got a message - Unable to Create a Temporary folder. I used to be able to open more than one job window.
Posted by Simon Garrison, 4 months ago
S
I created some DFM profiles and panel sizes in the software that it would like to share with my colleagues. Is that possible?
Posted by Simon Garrison, 5 months ago
S
Gerber import error - UNable to create pad. Pad found with 0 or Negative Width, invalid. Warning: Unable to Create Pad - Flashes Cannot be Zero Width - Invalid Dcode Unable to Add Flash.
Posted by Simon Garrison, 5 months ago
S
DFM Error PDF report doesn't match Error List
Posted by Simon Garrison, 5 months ago , Last Reply by Simon Garrison 5 months ago
S
Aperture: Rectangle/ Custom(MACRO)
Posted by Simon Garrison, 5 months ago
S
Is it possible for me to remove any DFM errors that are Incorrect (i.e false positive)?
Posted by Simon Garrison, 5 months ago
S
How can I cut out a small section of my design? It can be helpful when needing to share only a small area of my design IP.
Posted by Simon Garrison, 5 months ago
S
How can I toggle all DFM Rules On/Off?
Posted by Simon Garrison, 5 months ago , Last Reply by Simon Garrison 5 months ago