-
Is there any difference between PCB Preflight and FAB3000, such as the inspection items? Is there any difference table?
-
Is there backdrill and HDI DFM check? If so, how to import Gerber files to complete the check, settings, etc.
-
FAB3000 and SPEA
-
How To Change D-Codes In FAB3000.
-
Malfunction selection option. Cannot place editor in "Single Selection Mode". It's always either "Add Selection" or "Sub Selection".
-
May I get some assistance with setting up the FAB 3000 Flexnet floating on our license server?
-
NC Rout/Mill export not correct
-
We're trying to export the drills on our tgz files as flashes but after several combinations we can't get best recipe to obtain the best results, in the past we used a different sw (gerbtool) to get this result, the final purpose is print transparency fil
-
I need to know how I can cut a polygon existing in customer gerber file ? for example below, you can see a polygon filled around pads, I want cut this polygon on the red line :
-
I succes to panelize my PCB, in panel setup i have add my dimensions, fiducial, tooling hole, I have synchronize my layers and I have finish my panel but like you can see below in my panel, I have no fiducial, no tooling hole and no copper filled panel
Sorted by