CAM Engineering and DFM Questions (1116)

When I run a DFM check, the software becomes unresponsive.

Posted almost 7 years ago by Simon Garrison

In some multi-panel layouts I have the requirement to add tabs at specific places so they are accessible after component placement. Can I add tabs in the panel layout or just in jobs?

Posted almost 7 years ago by Simon Garrison

Add Tabs - Tab drill hits for the mouse bites reside on the rout file and not the drill file. How do I place the drill hits for the mouse bits on another layer (beside route)?

Posted about 7 years ago by Simon Garrison

print to PDF files not sharp (clear)

Posted about 7 years ago by Simon Garrison, Last Reply by Simon Garrison about 7 years ago

Workspace Corrupted files

Posted about 7 years ago by Simon Garrison

How can I create a fillet between a trace and a pad. Is this possible, or not part of the tool suite?

Posted about 7 years ago by Simon Garrison

Loading ODB++ files takes forever

Posted over 7 years ago by Danny Carr

I'm not getting accurate results when performing Netlist comparison, what's going on?

Posted over 7 years ago by Simon Garrison

What is the new COMPOSITE feature for the JOB Array?

Posted over 7 years ago by Simon Garrison

What is a Polarity Conflict during Gerber Import?

Posted over 7 years ago by Simon Garrison, Last Reply by Danny Carr about 7 years ago