-
My PCB vendor is requesting that I include arcs in my Gerbers. My gerbers look perfectly fine in every viewer, so what are my options?
-
How accurate is FAB 3000 for Viewing, Measure, DRC, DFM, etc?
-
I have read and viewed how one can compare two PCB files for differences, however I am confused at the Job Tabs once both are imported.
-
I am getting hundreds of shorts when I run Netlist Compare on my Gerbers - however if I import an ODB++ and run Netlist Compare there are NO shorts (on the exact same design) - Why?
-
We manufacture SMT stencils, and I'd like to be able to use Query or List any SMT pads to quickly determine their Area and Aspect ratios. Do you have a solution?
-
During ODB++ Import, I'd like to substitute the component Part Number with a property like "CDS_LW_PART_NUMBER". Can this be done?
-
I had one question regarding gerber comparison that I would like to perform on the FAB 3000.
-
How do I rename layers in FAB 3000?
-
Does FAB3000 have features that help selecting stencil thickness, for exampel high-lighting pads with area ratio or aspect ratio below a specified value or high-lighting pads with a width smaller than a specified value (which indicates the number of solde
-
I try to design a stencil using FAB 3000 ,but I did not know how I can generate square aperture from circular aperture in case fine pitch BGA.
Sorted by