CAM Engineering and DFM Questions (1110)

Pads at unusual angles

Posted over 4 years ago by Dave LeMat

Gerber Layer Types are not all correctly detected in the Auto Load dialog. I am using the command (menu: File / Import / AutoLoad...)

Posted over 4 years ago by Simon Garrison

We need a separate routing layer for the panel outline itself. How can I accomplish this?

Posted over 4 years ago by Simon Garrison

I used DFM Now, and I sometimes want to compare two gerber file sets. Is that possible in the free software?

Posted over 4 years ago by Stefan.althoefer

Export slots on drill file

Posted over 4 years ago by Salvador Mendoza

AutoDwg unregistered

Posted over 4 years ago by Tom Veik, Last Reply by Simon Garrison about 3 years ago

Is there a way to select all the silkscreen under my selected parameters and then change propieties?

Posted over 4 years ago by Simon Garrison, Last Reply by Simon Garrison over 4 years ago

Using Panel Setup..

Posted over 4 years ago by Simon Garrison

Panel Setup - Venting

Posted over 4 years ago by Simon Garrison

Panel Setup - Tooling Holes

Posted over 4 years ago by Simon Garrison, Last Reply by Simon Garrison 8 months ago , 1 Vote