CAM Engineering and DFM Questions (1092)

I find it sometimes confusing when I can see a file in the job list, but it is hashed out, so not accessible.

Posted about 4 years ago by Simon Garrison, Last Reply by Simon Garrison about 4 years ago

Can I create a drill table, where the software counts all of my drills and creates a table like this for my panel?

Posted about 4 years ago by Simon Garrison

Pads at unusual angles

Posted about 4 years ago by Dave LeMat

Gerber Layer Types are not all correctly detected in the Auto Load dialog. I am using the command (menu: File / Import / AutoLoad...)

Posted about 4 years ago by Simon Garrison

We need a separate routing layer for the panel outline itself. How can I accomplish this?

Posted about 4 years ago by Simon Garrison

I used DFM Now, and I sometimes want to compare two gerber file sets. Is that possible in the free software?

Posted about 4 years ago by Stefan.althoefer

Export slots on drill file

Posted about 4 years ago by Salvador Mendoza

AutoDwg unregistered

Posted about 4 years ago by Tom Veik, Last Reply by Simon Garrison almost 3 years ago

Is there a way to select all the silkscreen under my selected parameters and then change propieties?

Posted about 4 years ago by Simon Garrison, Last Reply by Simon Garrison about 4 years ago

Using Panel Setup..

Posted about 4 years ago by Simon Garrison