PDF to DXF

Posted over 3 years ago by Simon Garrison

Post a topic

Simon Garrison Admin

I would appreciate, if you could advise me on one matter (of course, I searched on community forums, but I could not find an answer).

Namely, I could import pdf and export to dxf successfully for almost all layers. However, there are a couple of layers, which I could not manage.

Namely, FAB 3000 interprets one layer as two layers.

Yet, it is desirable to have one layer, in accordance with the original document.

I would greatly appreciate your support.

Respectfully,

Vladimir.

0 Votes

1 Comments

Simon Garrison posted over 3 years ago Admin

Hello Vladimir,

Thanks for your question.

To get the results you require during PDF Import, please set the following option:

Map Layers: to "Merge All To a single Layer"
Fill Area Mode: "Treat White Areas as Holes (Auto-Detect)" or "Treat White Areas as Holes (De-embed)"

Best regards,

Simon

0 Votes