How to select (or highlight) the holes with same size?And how to turn off the grid? : Numerical Innovations

Start a new topic

How to select (or highlight) the holes with same size?And how to turn off the grid?

Joffer

started a topic about 8 years ago

I realize that if I goto "Query Dcode", and then click a line in Gerber, all the line in the same Dcode will be highlighted.

Then, is there a way to select or highlight all the holes with same size? The holes do not have Dcode after importing.

And, see the attached picture, there will alaways be grid when I enlarge some places, is it able to turn the grid off?

example.jpg

(27.8 KB)

1 Comment

Simon Garrison

said about 8 years ago

Thanks for your excellent questions.

TURN GRID OFF:

Go to menu: Setup / Set Grid...
For Display select "Grid Off"
Press OK, and the grid will no longer be visible.

SELECT HOLES BY SIZE:

Using the selection filter, FAB 3000 can select holes the same size or within a range that you provide. So for example it's possible to select holes between 1mm and 2.5mm, or traces less than 10 mil diameter, etc. You can also save those selection filters for easy access later. Please perform the following:

Determine the size (i.e. range) for the objects you wish to select. I will assume 0.06 inch for this example:

Go to menu: Edit / Selection / Filter...
Go to section "Names", and in the box Shapes.
Enter: width=0.06
Press OK,
Select Objects, now only objects with 0.06 with will be selected.

Here's some sample forum posts which may help.

http://screencast.com/t/NRM3NN5xA

https://numericalinnovations.freshdesk.com/support/discussions/topics/14000003345

Best regards,

Simon

Numerical Innovations - Help Center

How can we help you today?