CAM Engineering and DFM Questions (1105)

Can I change the FAB 3000 system font for dialogs, menus, etc.? I'd prefer to use another font which is easier for me to read menu options.

Posted over 15 years ago by Numerical Support Team

STEP Conversion

Posted over 15 years ago by Numerical Support Team, Last Reply by Numerical Support Team over 15 years ago

Gerber to Drill

Posted over 15 years ago by Numerical Support Team, Last Reply by Numerical Support Team over 15 years ago

Installing FAB 3000 for Linux on Ubuntu

Posted over 15 years ago by Numerical Support Team, Last Reply by Numerical Support Team over 15 years ago

Does Numerical Innovations have a free Gerber view?

Posted almost 16 years ago by Numerical Support Team

Convert Scanned PDF to Gerber.

Posted almost 16 years ago by Numerical Support Team, Last Reply by Numerical Support Team almost 16 years ago

I am looking for a software that can take the entire DWG file and run a DRC check

Posted almost 16 years ago by Numerical Support Team, Last Reply by Numerical Support Team almost 16 years ago

I can't find how to bring the object back to the center of the screen.

Posted almost 16 years ago by Numerical Support Team

Is there a method in this software to count the number of apertures/SMT pads for a given layer?

Posted almost 16 years ago by Numerical Support Team, Last Reply by Numerical Support Team almost 16 years ago

Is there any way to convert a layer to drill and replace the original rather than just adding the drills to the flashes?

Posted almost 16 years ago by Numerical Support Team, Last Reply by Dave Collins over 8 years ago