CAM Engineering and DFM Questions (1092)

Can you change the Minimum Trace and other DFM Check Values? I don't want to use 5 mils.

Posted about 13 years ago by Numerical Support Team

I'm an getting "additional" Open Nets/External errors which I believe are not correct

Posted about 13 years ago by Numerical Support Team, Last Reply by Numerical Support Team about 13 years ago

Trying to extract a netlist from my Gerber Files

Posted about 13 years ago by Numerical Support Team, Last Reply by Numerical Support Team about 13 years ago

I got a different number of Nets Extracted, how come?

Posted about 13 years ago by Numerical Support Team, Last Reply by Numerical Support Team about 13 years ago

How can I convert a PDF file (of a PCB) into real gerber and drill files?

Posted about 13 years ago by Numerical Support Team

Standard name for Gerber file

Posted about 13 years ago by igeorge, Last Reply by igeorge about 13 years ago

I exported a exc drill file after editing it in Fab3000, looks good. But, I cannot find the drill sizes in the file, can you point them out?

Posted about 13 years ago by Numerical Support Team, Last Reply by Numerical Support Team about 13 years ago

"Not a gerber file" error

Posted about 13 years ago by Jim Manley, Last Reply by Numerical Support Team about 13 years ago

I exported and imported Gerber files, and ran DRC
minimum gap repeatedly, the errors are not always at the same points.

Posted about 13 years ago by Numerical Support Team, Last Reply by Numerical Support Team about 13 years ago

I want to see if the netlist embedded in ODB++ checks against the ODB++ artwork open nets, plane shorts and opens etc,

Posted over 13 years ago by Numerical Support Team, Last Reply by Numerical Support Team over 13 years ago