CAM Engineering and DFM Questions (1116)

After importing my NC Rout file, I noticed an invalid plunge/retract point which I need to remove. I tried using Join Wizard (Automatic) to remove it, however is there an easier way.

Posted about 8 years ago by Simon Garrison

How to update Fab 3000?

Posted about 8 years ago by Danny Carr

How do I trim back an existing ground plane layer, I tried the trim command but that didn’t work? Would this be by dragging the vertexes (which seem to work)?

Posted about 8 years ago by Simon Garrison

I was able to add the mouse bites but I haven’t gotten them where they need to be (75% inside of board outline) Would this be offset I need to adjust?

Posted about 8 years ago by Simon Garrison

Can't launch Fab3000v7 on Win10

Posted about 8 years ago by Billie Torreno, Last Reply by Simon Garrison about 8 years ago

The drill file generated has many digits without any points or commas. How can I add a Decimal places to the drill file output?

Posted about 8 years ago by Simon Garrison

Where can I find the sample LUA apps installed with FAB 3000?

Posted about 8 years ago by Simon Garrison

Moving around in FAB 3000

Posted about 8 years ago by Danny Carr

Using negative gerber export with an array

Posted about 8 years ago by Tom Veik, Last Reply by Danny Carr about 8 years ago

How can I change the workspace tab name?

Posted over 8 years ago by Mariusz, Last Reply by Simon Garrison about 8 years ago