-
How can I toggle all DFM Rules On/Off?
-
How can I cut out a small section of my design? It can be helpful when needing to share only a small area of my design IP.
-
Is it possible for me to remove any DFM errors that are Incorrect (i.e false positive)?
-
Aperture: Rectangle/ Custom(MACRO)
-
DFM Error PDF report doesn't match Error List
-
Gerber import error - UNable to create pad. Pad found with 0 or Negative Width, invalid. Warning: Unable to Create Pad - Flashes Cannot be Zero Width - Invalid Dcode Unable to Add Flash.
-
I created some DFM profiles and panel sizes in the software that it would like to share with my colleagues. Is that possible?
-
I got a message - Unable to Create a Temporary folder. I used to be able to open more than one job window.
-
when importing layers I see 2 nodes which are not connected (many nodes are connected correct), while my colleague has the same version and same settings and he has the nodes correct connected after importing GKO layer.
-
I'd like to create a PDF representation of the panels that I make that show the frame of the panel and array/matrix of the PCB when submitting to board vendors. When I go to generate this PDF all I am able to see is the matrix/array grid and the lines fo
Sorted by