How can we help you today?

Start a new topic
Discussions FAB 3000 - Gerber/CAM Software
FAB 3000 - Gerber/CAM Software 978

Online Support and FAQ for FAB 3000.

N
Can FAB 3000 load two ODB++ files at once?
Posted by Numerical Support Team, about 11 years ago
N
I had a problem loading an aperture table yesterday, I tried the creating a new import rule but I didn’t quite get what I had to do?
Posted by Numerical Support Team, about 11 years ago , Last Reply by Numerical Support Team about 11 years ago
N
Problem with Gerber Arcs
Posted by Numerical Support Team, about 11 years ago
N
Does FAB 3000 supports Polar and Relative coordinates?
Posted by Numerical Support Team, about 11 years ago , Last Reply by Numerical Support Team about 11 years ago
N
I am using DFM Now! and I want to create a gerber using some files I had. When I select export a pop up says I need to register.
Posted by Numerical Support Team, about 11 years ago , Last Reply by Numerical Support Team about 11 years ago
N
Export to ODB ++
Posted by Numerical Support Team, about 11 years ago
N
Extract Netlist
Posted by Numerical Support Team, about 11 years ago
N
Can you have a look at this FAB 3000 workspace file and see if you can extract a netlist?
Posted by Numerical Support Team, about 11 years ago , Last Reply by Numerical Support Team about 11 years ago
N
I've been trying to convert DXF/Gerber file to NC Drill file. I've been through your forum but could not create it.
Posted by Numerical Support Team, about 11 years ago , Last Reply by Numerical Support Team about 11 years ago
N
I've been trying to convert DXF/Gerber file to NC Drill file.
Posted by Numerical Support Team, over 11 years ago